Download radio update for g1

I had an issue with my G1M, it would turn on and you can hear static, but no display. Since I also own G90, that behavior was very familiar. If you leave G90 connected to the computer via CAT cable when powering on, sometimes that will wipe out your frimware, causing the exact same behavior. The only fix is to re-load the firmware.

I got my G1M from Radioddity so I reached out to them for help. At that time, about 2 weeks ago, they did not have the firmware posted. After going back and forth with support couple of times, they finally emailed me the 1. The firmware file was created on June 9th, and my radio was only couple of weeks old at that point, so in my case there is a good chance that 1.

Update process is exactly the same as G90, using TeraTerm and all the same settings. If you are going to do an update, before you start, grab G90 firmware v1. Follow the instructions, but of course use G1M firmware file instead of G Firmware re-load fixed the issue and my G1M is alive again. I have no idea what my firmware version was before the issue happened and what Radioddity emailed didn't have any documentation or change logs included.

So there is a possibility that if you have an older G1M, sold before June 9th, that it may be an upgrade. I did not notice any obvious changes, but I'm not a CW op, so if something is different in that part of the radio, I would never pick up on that.

Be careful with your CAT cable, unplug it before powering the radio back on, and good luck! This cannot be undone. The Group moderators are responsible for maintaining their community and can address these issues.

Report to Groups. This includes: harm to minors, violence or threats, harassment or privacy invasion, impersonation or misrepresentation, fraud or phishing. Note: Your email address is included with the abuse report. Toggle navigation.

Home Messages Hashtags. Search Cancel. Date Date 1 - 4 of 4 previous page next page. Hello Group. I received my G1M recently. NOTE - Before connecting the device strobe or radio trigger etc to your computer via a PC sync cord, its important to make sure the flash or trigger is turned OFF first. Godox use various methods to access and display the firmware version currenly installed on their flashes and radio triggers —. Firmware version is displayed.

Hold the GR button, and turn the device ON. V - Turn flash OFF. Hold the Fn button, and turn the device ON. Fn button and the firmware version is displayed at the top right corner. If all else fails, each products Instruction Manual should detail how the firmware version can be accessed.